Create Plan View Block from This Drawing

The Create Plan View Block from This Drawing command is used to configure your current drawing to work as a custom photometrics block.

This command will not create a slide for the block. You can manually create a slide for the block using the Create Slide command.

To configure the current drawing as a block, go to
Ribbon: DM Photo: Customization→Block Creation→  Create Plan View Block from This Drawing
Pulldown Menu: DM Photometrics→Customization→Block Creation→Create Plan View Block from This Drawing

You will be prompted to specify the insertion point for the block.

Specify insertion base point:

The Design Master Photometrics dialog box will appear.

Press the button to connect loops to the edges of a circle on this block. Press the button to connect loops to the edges of a rectangle on this block. Press the button to connect loops to points on this block.

Connecting Loops to the Edge of a Circle

If the button is pressed, you will be prompted to specify a point on one side of the circle.

Specify a point on one side of circle:

You will then be prompted to identify a point on the opposite side of the circle.

Specify a point on opposite side of circle:

Connecting Loops to the Edge of a Rectangle

If the button is pressed, you will be prompted to identify the location of the first corner of the rectangle.

Specify first corner of rectangle:

You will then be prompted to identify the location of the opposite corner.

Specify opposite corner of rectangle:

Connecting Loops to Points on the Device

If the button is pressed, you will be prompted to identify the location where the loop is to connect to the device.

Specify connection point:

Specify as many connection points as desired for the block. Press ENTER to finish the command.